Configure Wpa Or Wpa2 Personal (Psk) Security; With Funk Security; Configure 802.1X Security With Funk Security - Intermec CN51 User Manual

CN51 Mobile Computer User Manual
Configure WPA or WPA2 Personal (PSK) Security with
Funk Security
Before you set WPA or WPA2 Personal (PSK) security, you need to
know the pre-shared key for your access point or passphrase for your
authenticator. On your computer, you need to enable the radio and set
the date.
1 Start Intermec Settings.
2 Select Communications > 802.11 Radio > Funk Security.
3 Select a Funk security profile to configure.
4 Enter the SSID.
5 For Association, select WPA or WPA2.
The default encryption is TKIP or AES, respectively.
6 For 8021x, select None.
7 For Pre-Shared Key, enter the pre-shared key or passphrase:
Enter the pre-shared key (0x followed by 32 hexadecimal pairs)
•
for your access point.
• Enter the passphrase (8 to 63 ASCII characters) for your
authenticator. The computer internally converts the passphrase
to a pre-shared key.
8 Tap OK.

Configure 802.1x Security with Funk Security

Before you set 802.1x-WEP security with Funk security, you need to
enable the radio on your computer and set the date. To use TLS
protocol, you also need to load a user and root certificate. Intermec
recommends that you use WPA2-802.1x instead of 802.1x-WEP if
possible.
1 Start Intermec Settings.
2 Select Communications > 802.11 Radio > Funk Security.
3 Select a Funk security profile to configure.
4 Enter the SSID.
Chapter 6 — Configure the Computer
97