Bosch INTEGRUS Installation And Operating Manual page 45

INTEGRUS | Digital Infra-red Language Distribution System
Mounting on a floor stand
The top of the floor stand is screwed into the suspension bracket (Figure 3.5). The bracket is supplied with both metric and
Whitworth threaded plates, and is therefore compatible with most standard floor stands. For floor stands, the mounting angle
can be set at 0°, 15° or 30°.
Figure 3.5 Attaching the stud of a floor stand to the suspension
bracket of the radiator
Wall mounting
For wall mounting, an extra wall bracket (LBB 3414/00) is required (must be ordered separately). This bracket is attached to the
wall by means of four bolts (see Figure 3.8). Four holes of 10 mm in diameter and 60 mm in depth must be drilled using the
drilling pattern (see Figure 3.7).
: The four bolts used to attach the bracket must each be able to withstand a pull-out force of 200 kg (440 lb). The bolts and plugs delivered with
the LBB 3414/00 wall bracket are only intended for mounting the unit on a solid brick or concrete wall.
Figure 3.7 LBB 3414/00 wall mounting bracket showing
dimensions and drilling pattern
Figure 3.6 Attaching the radiator inclusive suspension bracket and
stud to the floor stand
BOSCH Security Systems | February 2003
en |
45