Configuration And Operation; Start-Up; Main Menu; View Transmitter Status - Bosch INTEGRUS Installation And Operating Manual

| en
36

2.5 Configuration and operation

The next sections give descriptions of the possible configuration options. Each description is followed by the relevant menu
items with detailed information per menu option.
The default values (see section 'Reset all options to factory defaults') are indicated by an asterix (*) when applicable.
2.5.1

Start-up

When the transmitter is switched on, the display shows the Transmitter Status screen, which is the first item of the Main menu.
The display also goes to this screen after 5 minutes of inactivity.
2.5.2

Main menu

The main menu contains the screens to view the transmitter status and the radiator fault status. It also contains the entry points
to the Monitoring, Enquiry and Setup sub-menus.
Menu Item
Transmitter Status
1 Fault Status
2 Monitoring ...
3 Enquiry ...
4 Setup ...
2.5.3

View transmitter status

The first screen of the Main menu gives information about the present status of the transmitter. The screens shows the name of
the transmitter (1st line) and the present transmission mode (2nd line). See examples below. See section 2.5.7 to change the
transmission mode.
Transmitter
10 Channels DCN
Transmitter is transmitting 10 channels
from DCN.
Menu Items
Transmitter Status
BOSCH Security Systems B.V.| February 2003
INTEGRUS | Digital Infra-red Language Distribution System
Description
Shows the transmitter status (see section 2.5.3)
Shows the radiator fault status (see section 2.5.4)
Go to the 'Monitoring' sub-menu (see section 2.5.5)
Go to the 'Enquiry' sub-menu (see section 2.5.6)
Go to the 'Setup' sub-menu (see sections 2.5.7 and higher)
Transmitter
Aux to All
Transmitter is transmitting the Aux inputs
on all channels.
Options (read only)
Name
Mode:
- nn Channels
- Aux to All
- nn Ch. Test
- Slave
- Standby
- Emergency Call
DCN
Description
The first line shows the user defined name of the transmitter (see
section 2.5.15).
The second line shows the actual transmission mode:
Audio signals are distributed on nn channels.
The signal on the Aux. inputs is distributed on all channels.
The test signals are distributed on nn channels.
The transmitter operates in slave-mode: the radiator signal on the
slave input is looped-through to all radiator outputs.
The transmitter is in stand by mode.
An emergency signal from the Aux. inputs is distributed to all
channels.
The text 'DCN' is shown at the right side of the second line when a
DCN system is connected to the transmitter.
Transmiter
Standby
Transmitter is in Standby mode (not
transmitting)