Connecting To Another Transmitter - Bosch INTEGRUS Installation And Operating Manual

| en INTEGRUS | Digital Infra-red Language Distribution System
30
2.3.4

Connecting to another transmitter

The transmitter can be operated in slave mode to loop-through the IR radiator signals from a master transmitter. One of the
four radiator outputs of the master transmitter is connected with an RG59 cable to the radiator signal loop-through input of the
slave transmitter.
The Transmission mode of the slave transmitter must be set to 'Slave' (see section 2.5.7).
MASTER SLAVE
Figure 2.11 Connecting to another transmitter
BOSCH Security Systems B.V.| February 2003