Download  Print this page

Cable Installation And Removal - Honeywell VoyagerGS 9590 Series User Manual

Single-line hand held laser scanner
Hide thumbs

Advertisement

I
NTRODUCTION

Cable Installation and Removal

Installation
Important: If the cable is not fully latched, the unit can power intermittently.
1.
Plug the 10-pin RJ45 end of the cable into the 10-pin socket on the scanner.
There will be an audible click when the connector lock engages.
2.
Gently pull on the cable strain relief to insure the cable is securely installed.
Removal
Before removing the cable from the scanner, Honeywell recommends that power
to the host system be turned off. If the cable is a PowerLink cable, disconnect
the power supply on the cable.
1.
Locate the small dimple on the handle of the unit near the cable connection.
2.
Bend an ordinary paperclip into the shape shown above in Figure 3.
3.
To release the cable lock, push the end of the paperclip through the rubber
on the handle where the dimple is located.
4.
There will be an audible click when the connector lock releases. Pull gently
on the strain-relief of the cable to separate the cable from the scanner.
Figure 2. Connecting the Cable
Figure 3. Releasing the Cable
5

Advertisement

Table of Contents
loading

  Related Manuals for Honeywell VoyagerGS 9590 Series

This manual is also suitable for:

Voyager gs 9590 series