Cable Installation And Removal - Honeywell MS5145 – 00 User Manual

Cable Installation and Removal

Installation
1. Insert the cable's modular connector into the socket on the
scanner.
2. Pull gently on the cable strain relief to ensure the cable is
installed.
Note: If the PowerLink cable is not fully latched, the unit can
power intermittently.
Removal
Disconnect the power supply from the PowerLink cable and turn
off power to the host system before removing the cable from the
scanner.
1. Locate the small 'pin-hole' on the
front side of the scanner near the
end of the handle.
2. Bend an ordinary paperclip into the
shape shown.
3. Insert the paperclip (or other small
metallic pin) into the small 'pin-hole'.
There will be a faint 'click' when the
connector's lock releases.
4. Pull gently on the cable's strain-relief
to remove the cable.
Figure 3.
Figure 4.
4