Sys Reset Page - DigiDesign Control 24 Manual

To access footswitch SW1 settings:
Press the flashing encoder switch below the
label "SW1."
The text label "SW1" will be displayed on the far
right dual 4-character scribble strip display in
the CHANNEL BAR.
PlayStop is the default function choice and is
indicated by the solidly lit encoder switch LED
below this choice.
Footswitch 2 Page
This mode allows you to program the function-
ality of a SPST switch connected to the SW2 _"
jack located on the rear panel of Control|24.
The choices are Play/Stop, Record in/out, and re-
mote talkback. You can also change the polarity
of the switch closure.
To access footswitch SW1 settings:
Press the flashing encoder switch below the
label "SW2."
The text label "SW2" will be displayed on the far
right dual 4-character scribble strip display in
the CHANNEL BAR.
Talkback is the default function choice and is in-
dicated by the solidly lit encoder switch LED be-
low this choice.
140 Control|24 Guide

Sys Reset Page

The Sys Reset page allows you to reset Con-
trol|24 to the factory default settings.
To reset Control|24:
Press the UTILITY switch. The switch LED
1
flashes, indicating that a special mode has been
entered.
The text label "Util menu" will be displayed in
2
the dual 4-character scribble strip displays in the
CHANNEL BAR and the UTILITY menu items
are displayed on the channel scribble strips as
outlined above.
The label "Sys Reset" appears on channel
3
scribble strips 11 & 12. Press the flashing en-
coder switch below the choice to start the reset
process.
The label "Sys Reset" will be displayed in the
4
dual 4-character scribble strip in the CHANNEL
BAR.
Press the flashing encoder switch below the
5
scribble strip showing "Cncl" to cancel out of
the sys reset function. Following this action, the
menu will be returned one level up.
Press the flashing encoder switch below the
6
scribble strip showing "Ok" to reset Control|24
to the default factory settings.
Press the flashing encoder switch below the
7
scribble strip showing "Cncl" to cancel out of
the sys reset function. Following this action, the
menu will be returned one level up.