DigiDesign Control 24 Manual page 130

AutoMatch Function
During playback, you can stop writing of auto-
mation on Write-enabled or Latch-enabled
tracks and return automation to previously writ-
ten levels by ramping up or down according to
the AutoMatch time.
To end an automation pass on a single Write- or
Latch-enabled track with AutoMatch:
During playback, at the point where you want
to stop writing automation on a track, press the
AUTO switch on its channel.
To end an automation pass on all tracks with
AutoMatch:
During playback, at the point where you want
to stop writing automation, hold
and press the AUTO switch on a Write- or Latch-
enabled channel.
Snap Back Function
During playback, you can stop writing of auto-
mation on Write-enabled or Latch-enabled
tracks and return automation instantly to previ-
ously written levels, ignoring any AutoMatch or
AutoGlide settings.
To end an automation pass on a single Write- or
Latch-enabled track with Snap Back:
During playback, at the point where you want
to stop writing automation on a track, hold
and press the AUTO switch on the chan-
(CTL)
nel.
To end an automation pass on all tracks with Snap
Back:
During playback, at the point where you want
to stop writing automation, hold
(CTL)+OPT(ALT)/ALL
on a Write- or Latch-enabled channel.
120 Control|24 Guide
OPT(ALT)/ALL
and press the AUTO switch
Join Function
The Join function is used in Latch mode to man-
ually resume writing of automation after the
transport is stopped and started again during an
automation pass.
To manually resume writing automation in Latch
mode:
After writing an automation pass, stop the
1
transport. The master LATCH switch flashes
when the automation for one or more controls
can be resumed in Latch mode.
Move the cursor back so that it is just before
2
the stop location.
Resume playback.
3
At the point where you want to start writing
4
automation, hold
(CTL)
master LATCH switch.
Automation recording continues for all controls
in Latch mode.
AutoJoin Function
The AutoJoin function is used in Latch mode to
automatically resume writing of automation af-
ter the transport is stopped and started again
during an automation pass.
To automatically resume writing automation in
Latch mode:
After writing an automation pass, stop the
1
transport. The master LATCH switch flashes
when the automation for one or more controls
can be resumed in Latch mode.
In the Automation Enable window, click the
2
AutoJoin button. A red line, the AutoJoin Indi-
cator, appears in the Edit window to show the
stop location.
and press the flashing