Table of Contents
Advertisement
NOTE!
When you install DIMM module fully into the DIMM socket the eject tab should be
locked into the DIMM module very firmly and fit into its indention on both sides.
WARNING! For the DDR SDRAM CLOCK is set at 200MHz, use only DDR400-compliant DDR
Modules. When this motherboard operate at 200Mhz, most system will not even
boot if non-compliant modules are used because of the strict timing issues, if your
SDR Modules are not DDR266-compliant, set the DDR SDRAM clock to 133MHz to
ensure system stability.
2-5 To install the Expansion Cards
WARNING!
Turn off your power when adding or removing expansion cards or other system
components.
motherboard and expansion cards.
2-5-1 Procedure For Expansion Card Installation
1.
To read documentations or manuals for your expansion cards and make any necessary
hardware or software settings for your expansion card such as jumpers.
2.
To remove your computer's cover and the bracket plate on the slot you intend to use.
3.
To align the card's connectors and press firmly.
4.
To secure the card on the slot with the screen you remove above.
5.
To replace the computer system's cover.
6.
To set up the BIOS if it's necessary.
7.
To install the necessary software drivers for your expansion cards.
DIMM1 & DIMM3: Dual Channel 1
DIMM2 & DIMM4: Dual Channel 2
Failure to do so may cause severe damage to both your
20
Figure 2-4
Advertisement
Table of Contents
