Table of Contents
Advertisement
2-3-3 LGA 775 CPU Installation Guide
Socket Preparation
1.
Opening the socket:
Note: Apply pressure to the corner with right hand thumb while opening/closing the load lever, otherwise
lever can bounce back like a "mouse trap" and WILL cause bent contacts (when loaded)
Socket Load
Plate Open
2.
Remove PnP Cap (Pick & Place Cap)
i.
With left hand index finger and thumb to support the load plate edge, engage PnP cap with right hand
thumb and peel the cap from LGA775 Socket while pressing on center of PnP cap to assist in removal.
ii.
Set PnP cap aside. Always put PnP cap back on if the processor is removed from the socket.
iii.
Visually inspect PnP cap for damage. If damage observed, replace the PnP cap.
1.
2.
3.
Socket Load
Lever Open
Note: After PnP cap removal, make sure socket load plate
Note: Optionally, remove PnP cap after CPU insertion. This
Disengage Load Lever by depressing down and out
on the hook to clear retention tab
Rotate Load Lever to fully open position at
approximately 135degrees
Rotate Load Plate to fully open position at
approximately 100degrees
and contacts are free of foreign material; Refer to
Overview Module for FM cleaning.
will compromise the ability to visually inspect socket.
10
Advertisement
Table of Contents
