Table of Contents
Advertisement
Generally speaking, installing DDR SDRAM modules to your motherboard is very easy, you can
refer to figure 2-4 to see what a 184-Pin PC2100/PC2700/PC3200 DDR SDRAM module looks
like.
NOTE!
When you install DIMM modules fully into the DIMM sockets the eject tab
should be locked into the DIMM modules firmly and fit to its indention on both
sides.
WARNING! For the DDR SDRAM CLOCK is set at 166MHz, use only PC2700-compliant
DDR Modules. When this motherboard operate at 133Mhz, most system will
not even boot if non-compliant modules are used because of the strict timing
issues, if your DDR Modules are not PC2100-compliant, set the DDR SDRAM
clock to 100MHz to ensure system stability.
2-5 To install the Expansion Cards
WARNING!
Turn off your power when adding or removing expansion cards or other system
components.
motherboard and expansion cards.
2-5-1 Procedure For Expansion Card Installation
1.
To read documentations or manuals for your expansion cards and make any necessary
hardware or software settings for your expansion card such as jumpers.
2.
To remove your computer's cover and the bracket plate on the slot you intend to use.
3.
To align the card's connectors and press firmly.
4.
To secure the card on the slot with the screen you remove above.
5.
To replace the computer system's cover.
6.
To set up the BIOS if it's necessary.
7.
To install the necessary software drivers for your expansion cards.
Failure to do so may cause severe damage to both your
10
Figure 2-4
Advertisement
Table of Contents
