Miscellaneous Control - JETWAY V600DA User Manual

Current CPU Temperature/Current System Temp/Current FAN1, FAN2 Speed/Vcore/
Vdd/ 3.3V/+5V/+12V/-12V/VBAT(V)/5VSB(V)
This will show the CPU/FAN/System voltage chart and FAN Speed.
Detect CPUFAN in Post
During Enabled, system will warn the user if CPU Fan is not functioning.

Miscellaneous Control

3-11
This section is for setting CPU Frequency/Voltage Control.
CMOS Setup Utility – Copyright(C) 1984-2003 Award Software
Auto Detect DIMM/PCI Clk
Spread Spectrum
** Current Host Clock is 133/33MHz **
Host/PCI Clock at Next Boot is
** Current DRAM Clock is 166MHz **
DRAM Clock at next Boot is
CPU Vcore Select
VDIMM Select
AGP VddQ Select
VCC2.5 Select
↑↓→← Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5:Previous Values
Auto Detect DIMM/PCI Clk
This item allows you to enable/disable auto detect DIMM/PCI Clock.
Spread Spectrum
This item allows you to set the CPU Host/PCI clock and Spread Spectrum.
The settings are: Enabled, Disabled.
Host Clock at next Boot is
This item allows you to select CPU frequency step by step increasing
The choice are: 100MHz∼132MHz, 133MHz∼165MHz, 166MHz∼255MHz.
DRAM Clock at next Boot is
This field displays the capability of the memory modules that you can use
The choice is either 100MHz or 133MHz or 166MHz or 200MHz.
AGP VddQ Select
This item allows you to select 1.5V of the AGP 4X/8X VGA card. The choice are: 1.5V,
1.6V.
VDIMM Select
This item allows you to select 2.5V of the DDR Module. The choice are: 2.5V, 2.6V, 2.7V,
2.8V.
Miscellaneous Control
Enabled
Disabled
133MHz/33MHz
By SPD
Default
2.5V (Default)
1.5V (Default)
2.5V (Default)
F6:Optimized Defaults
39
Item Help
Menu Level >
F7:Standard Defaults