JETWAY V600DA User Manual page 30

Enabled
CPU L1 Cache
The default value is Enabled.
Enabled (default)
Disabled
Note: The internal cache is built in the processor.
CPU L2 Cache
Choose Enabled or Disabled. This option enables the Level 2 cache memory.
Processor SSE Feature
Choose Enabled or Disabled. This option enables the AMD Athlon XP SSE Feature.
Quick Power On Self-Test
This category speeds up Power On Self Test (POST) after you power on the computer. If
this is set to Enabled.
Enabled (default)
Disabled
First/Second/Third/Fourth Boot Device
The BIOS attempts to load the operating system from the devices in the sequence selected in
these items. The settings are Floppy, LS/ZIP, HDD-0/HDD-1/HDD-3, SCSI, CDROM,
LAD and Disabled.
Swap Floppy Drive
Switches the floppy disk drives between being designated as A and B. Default is Disabled.
Boot Up Floppy Seek
During POST, BIOS will determine if the floppy disk drive installed is 40 or 80 tracks.
360K type is 40 tracks while 760K, 1.2M and 1.44M are all 80 tracks.
Boot Up NumLock Status
The default value is On.
On (default)
Off
Gate A20 Option
Normal
Fast (default) The A20 signal is controlled by port 92 or chipset specific method.
Activates automatically when the system boots up causing a warning
message to appear when anything attempts to access the boot sector
of hard disk partition table.
Enable cache
Disable cache
BIOS will shorten or skip some check items during POST.
Enable quick POST
Normal POST
Keypad is numeric keys.
Keypad is arrow keys.
The A20 signal is controlled by keyboard controller or chipset hardware.
25