Table of Contents
Advertisement
Power Button Function
Pressing the power button for more than 4 seconds forces the system to enter the Soft-Off state.
The settings are: Delay 4 Sec, Instant-Off.
Wake Up On Ring/PME
During Disabled, the system will ignore any incoming call from the modem. During Enabled,
the system will boot up if there's an incoming call from the modem.
Wake-Up by Alarm
This function is for setting date and time for your computer to boot up. During Disabled, you
cannot use this function. During Enabled, choose the Date and Time Alarm:
Date(of month) Alarm
You can choose which month the system will boot up. Set to 0, to boot every day.
Time(hh:mm:ss) Alarm
You can choose what hour, minute and second the system will boot up.
Note: If you have change the setting, you must let the system boot up until it goes to the
operating system, before this function will work.
3-9 Miscellaneous Control
This section is for setting CPU Frequency/Voltage Control.
CPU Spread Spectrum Clock
SATA Spread Spectrum
PCIE Spread Spectrum
Flash Part Write Protect
> IRQ Resources
PCI/VGA Palette Snoop
*** PCIExpress Relative Items ***
Maximum Payload Size
↑↓→← Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit
F5:Previous Values
Auto Detect PCI Clock
This item allows you to enable/disable auto detect PCI Clock.
Spread Spectrum
This item allows you to set the CPU Host / SATA / PCI clock and Spread Spectrum.
The settings are: Enabled, Disabled.
IRQ Resources
When resources are controlled manually, assign each system interrupt a type, depending on
the type of device using the interrupt.
Please refer to section 3-9-1
Phoenix – AwardBIOS CMOS Setup Utility
Miscellaneous Control
Enabled
F6:Optimized Defaults
Disabled
Disabled
Enabled
Press Enter
Disabled
4096
F7:Standard Defaults
32
Item Help
Menu Level >
F1:General Help
Advertisement
Table of Contents
