Table of Contents
Advertisement
INSTALLATION MANUAL
Page 18
Menu 2- Additional Settings
Setting 4 Button #4 Programmable
1) Trunk Release
2) Garage Door
3) Car Finder
Setting 5 Siren/Horn (Automatic transmission only)
1) Horn Output (+)
*2) Siren output
Press & Release the Program Button 5 Times (Setting 5) confirmed 5 LED flashes.
Press & Hold the Program Button until the appropriate # of park light/sirne chirps, then release.
Press & Release the Program Button to proceed to the next step.
Setting 5 Reservation Mode ("M" units only)
1) Manual Reservation
*2) Auto Reservation
Press & Release the Program Button 5 Times (Setting 5) confirmed 5 LED flashes.
Press & Hold the Program Button until the appropriate # of park light/sirne chirps, then release.
Press & Release the Program Button to proceed to the next step.
Menu 3- Starter Settings
Ignition ON-OFF-ON-OFF-ON
Press & Release Program Button
Press Button #3 (Start)
Setting 1 Special Door Lock/Unlock Operations (Factory Alarm Rearm).
1) Type 1
1 Flash/chirp
2) Type 2
2 Flashes/chirps
*3) Type 3
3 Flashes/chirps
Press & Release the Program Button 1 Time (Setting 1) Confirmed with 1 LED flashes.
Press & Hold the Program Button until the appropriate # of park lights/siren chirps, then release.
Press & Release the Program Button to proceed to the next step.
Setting 2 With 11 pin Connector- Gas/Diesel Mode (Auxiliary Connector Pin 12)
1) (+) Input
1 Flash/chirp
2) Time Delay
2 Flashes/chirps
*3) Gas/ (-) Input
3 Flashes/chirps
Press & Release the Program Button 2 Times (Setting 2) Confirmed with 2 LED flashes.
Press & Hold the Program Button until the appropriate # of park lights/siren chirps, then release.
Press & Release the Program Button to proceed to the next step.
Note:
Setting 2 will vary depending on the board layout 11 or 14 pin connectors.
1 Flash/chirp
2 Flashes/chirps
3 Flashes/chirps
1 Flash/chirp
2 Flashes/chirps
1 Flash/chirp
2 Flashes/chirps
Ignition 3x
On/Off
On/Off On
Unlock pulse before start. Lock pulse after start and on shutdown.
Lock pulse ONLY after remote start shutdown.
Default Lock/ Unlock Pulses.
(+) Glow Plug input. Waits maximum 30 seconds then starts.
Waits for approximately 15 seconds then remote starts.
Waits 2 seconds to start if no diesel input is detected.
2WAY REMOTE STARTER/ ALARM
...continued from previous page.
Holding button #4 will activate Trunk Release
Activates optional Garage Door Interface
Holding Button #4 activates Car Finder
Pulsed output for horn activation
Constant output for siren activation
Activate Reservation Mode by pressing # Button
Activate Reservation Mode by pressing brake
Press and
Release the
Press button
Program
3 to enter
Button
Program
Menu 3
1 2 3
4
Press and
Release the
Program Switch
1x =Setting 1
2x =Setting 2
3x =Setting 3....
*(Default Settings)
Press and
Hold the
Program Switch
1x = Option 1
2x = Option 2
3x = Option 3....
Advertisement
Table of Contents
