Table of Contents
Advertisement
Quick Links
Covers All 42xx and 43xx Series Remote Starter/Alarms
-The system must be placed into Service Mode before any service work is started on the vehicle. It is
the sole responsibility of the vehicle owner to ensure that this is done. The manufacturer accepts no
liability or responsibility for accidental starting of the vehicle.
- CARBON MONOXIDE - Never Start in an Enclosed Building (Garage, Carport etc...)
- The Hood Pin Safety Switch Must Always be Installed!
- Never Install Automatic Transmission Remote Starters into a Manual Transmission Vehicle!
Advertisement
Table of Contents
Related Manuals for Ultra Start 42xx
Summary of Contents for Ultra Start 42xx
- Page 1 Covers All 42xx and 43xx Series Remote Starter/Alarms -The system must be placed into Service Mode before any service work is started on the vehicle. It is the sole responsibility of the vehicle owner to ensure that this is done. The manufacturer accepts no liability or responsibility for accidental starting of the vehicle.
-
Page 2: Feature List
Our limited lifetime warranty provides one of the best protection plans in the industry, giving both the consumer and the retailer confidence when they invest in an Ultra Start product. FCC Notice This device complies with Part 15 of the FCC rules. -
Page 3: Extended Run Time
2WAY REMOTE STARTER/ ALARM Remote Start - Automatic Transmission Only 1.Press and release button #3. 2.The park lights will flash and the siren will chirp one time. 1 2 3 3.The vehicle will then remote start. The park lights will flash four times then remain on while the vehicle is running. -
Page 4: Reservation Mode - Manual Transmission Vehicles
OWNER’S GUIDE Page 4 Reservation Mode - Manual Transmission Vehicles Manual transmission remote starters must be set into Reservation Mode before the remote starter will activate. There are two different ways to place the system into Reservation Mode. The activation type of Reservation Mode is determined when the system is installed. -
Page 5: Trunk Release
2WAY REMOTE STARTER/ ALARM Alarm Features Lock Doors and Arm Alarm 1 2 3 1.Press and release button #1 on the remote transmitter. 2.The park lights will flash and the siren will chirp one time. 3.The doors will lock. 4.The LEDs on the antenna will start flashing within five seconds. Note: If installed, the starter disable will activate. -
Page 6: Temporary Shock Sensor Bypass
OWNER’S GUIDE Page 6 Alarm Features Shock Sensor Programming/ Adjustment To Enter Shock Sensor Programming Press and hold buttons #1 and #2 for three seconds. The park lights will flash and the siren will chirp three times. While the park lights are on strike the vehicle with the amount of force wanted to trigger the alarm*. -
Page 7: Cold Start Mode
2WAY REMOTE STARTER/ ALARM Cold Start Mode Cold Start Mode will start the vehicle at a user selectable start interval or temperature setting. The vehicle can be set to start once every 1, 2, 3 or 4 hours in Timer Mode or to start at 0,-5,-15 or -25 Celsius in Temperature Mode (LT Models Only) for a maximum 12 starts. -
Page 8: Lcd Display
OWNER’S GUIDE Page 8 LCD DISPLAY STATUS CHECK MODE This feature is used to check the status of the alarm system or the remote starter. 1. To check the status press and release Button #4 on the remote transmitter. 2. The remote will display the icons of the active features on the LCD screen. STATUS ICONS These icons are located at the top of the LCD screen. -
Page 9: Setting The Digital Clock
2WAY REMOTE STARTER/ ALARM Setting The Digital Clock To Enter Clock Adjust Mode 1 2 3 Press and hold buttons #1 and #4 until the minute portion of the clock located on the LCD begins to flash To Adjust The Time of day To set the minute, press and release button #3 to increase the minute or press button #2 to decrease the minute. -
Page 10: Entering Service Mode
OWNER’S GUIDE Page 10 Service Mode ATTENTION: TO AVOID SERIOUS INJURY, this remote start system must be set into Service Mode before any under hood servicing is started. Service Mode will prevent the vehicle from starting while the vehicle is being serviced. It is the sole responsibility of the vehicle’s owner to place the system into Service Mode. -
Page 11: Diagnostic Memory
2WAY REMOTE STARTER/ ALARM Diagnostics/ Diagnostics Chart If the remote starter does not activate when the start button is pressed the park lights will flash a diagnostic to indicate what shutdown input has been triggered. Example when the start button is pressed the park lights flash 3 times slowly. Looking at the chart below this would indicate that the system is in Service Mode. -
Page 12: Limited Lifetime Warranty
OWNER’S GUIDE Page 12 Limited Lifetime Warranty The manufacturer warrants to the original purchaser of their remote starters and alarms, that the product shall be free from defects in material and workmanship. However, should this product be proven to be defective, within a two year period from the original date of purchase, the manufacturer will, without charge to the purchaser (excluding any charges incurred to have the product delivered to the manufacturer), repair or replace any part of the remote starter and/or alarm which the manufacturer agrees...