Table of Contents
Advertisement
2WAY REMOTE STARTER/ALARM
Menu 1- User Settings..
Setting 6 Sensor Enable/Disable
1) Sensor Disabled
*2) Sensor Enabled
Press & Release the Program Button 6 Times (Setting 6) Confirmed with 6 LED flashes.
Press & Hold the Program Button until the appropriate # of park lights/ siren chirps, then release.
Press & Release the Program Button to proceed to the next step.
Setting 7 Passive/Active Arming
1) Passive Arming
2) Active Arming with Rearm
*3) Active Arming
Press & Release the Program Button 7 Times (Setting 7) Confirmed with 7 LED flashes.
Press & Hold the Program Button until the appropriate # of park lights/ siren chirps, then release.
Press & Release the Program Button to proceed to the next step.
Menu 2 - Additional Settings
Ignition ON-OFF-ON-OFF-ON
Press & Release Program Button
Press Button #2 (Unlock)
Setting 1 Secure Valet Mode - Length of time required to set the system into Service Mode
1) Secure Valet
*2) Normal Valet
Press & Release the Program Button 1 Time (Setting 1) confirmed 1 LED flashes.
Press & Hold the Program Button until the appropriate # of park light/sirenchirps, then release.
Press & Release the Program Button to proceed to the next step.
Setting 2 Parking Light/Trunk Output (14 pin auxiliary connector pins 2&8)
1) 30 sec. Output
2) Negative Park Lights
*3) Park Lights
Press & Release the Program Button 2 Times (Setting 2) confirmed 2 LED flashes.
Press & Hold the Program Button until the appropriate # of park light/siren chirps, then release.
Press & Release the Program Button to proceed to the next step.
Setting 3 Horn chirp Timing (14 pin auxiliary connector pin 5)
1) 5 ms Pulse Output
2) 15 ms Pulse Output
*3) 10 ms Pulse Output 3 Flashes/chirps
Press & Release the Program Button 3 Times (Setting 3) confirmed 3 LED flashes.
Press & Hold the Program Button until the appropriate # of park light/siren chirps, then release.
Press & Release the Program Button to proceed to the next step.
.
continued from previous page
1 Flash/Chirp
2 Flashes/Chirps
1 Flash/chirp
2 Flashes/chirps
3 Flashes/chirps
Ignition 3x
On/Off
On/Off On
1 Flash/chirp
2 Flashes/chirps
1 Flash/chirp
2 Flashes/chirps
3 Flashes/chirps
1 Flash/chirp
2 Flashes/chirps
INSTALLATION MANUAL
Impact Sensor Disabled
Impact Sensor Enabled
Auto Arms 30 seconds after last door is closed
If unlock is pressed and no door is opened
Arms with remote transmitter only
1 2 3
4
Press and
Release
Press button
the Program
2 to enter
Program
Button
Menu 2
Hold the Program Button for 15 seconds
Hold the Program Button for 5 seconds
Park Lights on for 30 seconds when Unlock is pressed
Switches the Park Lights/Trunk Outputs
2 Park Light Flashes when Unlock is pressed
Short(Quiet) Horn Output Pulses
Long(Loud) Horn Output Pulses
Normal(Medium) Horn Output Pulses
Page 17
Press and
Press and
Release the
Hold the
Program Switch
Program Switch
1x =Setting 1
1x = Option 1
2x =Setting 2
2x = Option 2
3x =Setting 3....
3x = Option 3....
*(Default Settings)
Advertisement
Table of Contents
