Assembly; Flexible Hose And Swivel Joint; Control Handle; Cabling - Husqvarna 130BT Operator's Manual

English

FLEXIBLE HOSE AND SWIVEL JOINT

1. Connect the blower and swivel joint with flexible hose. Clamp both ends of the
flexible hose securely with the hardware supplied with the unit.
(1) Flexible hose
(3) Clamp (large)
NOTE
A light lubricant may be used to ease assembly of flexible hose to blower tube.

CONTROL HANDLE

1. Set up the handle holder to the swivel joint and tighten the knob on the holder.
When setting up the handle holder, please make sure to match the handle holder to the
convex on the swivel joint as shown in F2.
2. Adjust the position and angle to achieve a comfortable working position, and tighten
the control handle.

(1) Cabling

(2) Flexible Hose
CABLING
130BT
• Fasten the cabling at central position of the hose by the band attached to the cabling.
First, wrap the flexible hose with the band fixed to the cabling from the lower side.
Then, pass the band through a hole of the band as shown in figure.
Please note that there is a possibility of damaging the flexible hose if the band is
fastened too tightly.
350BT, 370BTS, 380BTS
• Use the clamp to fasten the cabling to the flexible hose.
(1)Clamp

HANDLEBAR (OPTION)

1. Insert the holder, then assemble the handlebar (OPTION) and tighten it securely.

BLOW PIPES

Conect the swivel joint, straight pipe and pipe end. Push the pipes together and turn
them so they lock in relation to one another until the connection is locked.
NOTE
A light lubricant may be used to ease assembly of the blower tube.
NOTE
If longer tube is required, the second straight pipe can be connected with the
first one.
If higher air speed is required, the round blow pipe can be replaced by the flat
nozzle with the second straight pipe.
(1) Flat nozzle (option).
14

Assembly

(2) Swivel Joint
(4) Clamp (small)
F1
(3)
(1)
(4)
(2)
F2
(2)
(1)
F3
(130BT)
F4
(1)
(350BT, 370BTS, 380BTS)
F5
F6
(1)
F7