SMARTRACK 116 SWITCH
Reliable earthing of rack-mounted equipment should be maintained. Give attention to
supply connections other than direct connections to the branch circuit (e.g. use of
power strips).
3.4 Connecting to a rack
Note! For increased rack depth of between 800 ~ 990mm, first change the
bracket to the medium or long bracket, see section 3.5 on page 9.
Note! The illustrations below show the connections to one side of the SmartRack 116.
The connections are the same for the other side.
1. Move the rail until two screws appear, see Figure 1.
Figure 1 Exposing the 2 screws
2. Loosen slightly the 7 screws as shown below.
Figure 2 Loosen 7 screws
3. Adjust the rear bracket to fit your cabinet, see below.
Figure 3 Adjusting the bracket
4. Install the front and rear bracket onto the cabinet, see figure below.
7