Table of Contents
Advertisement
5.2.7 The Time settings
In the Settings window navigate to the Time line and press Enter
window appears see Figure 28.
5.2.7.1 Scan (SCN) - Label (LBL) - Time out (T/O)
SCN - In the SCN column, change the scan period.
LBL - In the LBL column, change the display period of the OSD label showing
which computer is currently accessed.
T/O - When password protection is activated you can automatically disable the
en password protection is activated you can automatically disable the
Management keyboard, mouse and screen after a preset time of non
keyboard, mouse and screen after a preset time of non-use. Set this
Timeout period in the T/O column.
To set the above periods:
1. On the desired line press Tab to jump to the desired column.
2. Place the cursor over one of the 3 digits and type a new number. Enter a leading
Place the cursor over one of the 3 digits and type a new number. Enter a leading
zero where necessary. For example, type 040 for 40 seconds.
Typing 999 in the LBL column displays the label continuously. Typing 000
label will not appear.
Typing 999 in the T/O column disables the Timeout function.
000 causes the Timeout function to work immediately. Minimum time should be
not less than 005 seconds.
Typing 999 in the SCN column displays the screen for 999 seconds. Typing 000
the computer screen is skipped.
5.2.8 Users
In the Settings window navigate to the Users line and press Enter
only enabled if the security status is set to On, see page 19). The Users settings
window appears see Figure 29.
SMARTRACK 116 SWITCH
Figure 28 Time settings window
change the display period of the OSD label showing
column displays the label continuously. Typing 000 – the
disables the Timeout function. Warning! Typing
displays the screen for 999 seconds. Typing 000 –
23
Enter. The Time settings
Minimum time should be
Enter. (Note! Users is
The Users settings
Advertisement
Table of Contents
