5. Repeat the above steps for the other side.
6. Go to section 3.4 Connecting to a rack.
3.6 Connecting the KVM Switch 116
1. Connect the bracket A to the sides of the Switch using the two 6mm screws
provided see figure below.
2. Slide the Switch 116 into the rail and into the back of the SmartRack console
until you hear a click. See the figure below.
3. Secure the Switch 116 to the rail by inserting the thumbscrews through the bracket
and into the rail and tightening them, see Figure 16.
SMARTRACK 116 SWITCH
Figure 13 Inserting and tightening the medium/long bracket
Figure 14 Connecting the bracket A to the sides of the Switch
Figure 15 Slide switch into back of SmartRack
11