2. Take the rear bracket out, see below.
3. Insert the medium/long bracket into the rail then adjust the bracket to fit your
cabinet.
4. Tighten at least 2~3 screws along the length you need. Note! For medium bracket
use the round screws
Figure 13.
5. Repeat the above steps for the other side.
6. Go to section 2.3 Connecting to a rack.
2.5 Connecting the KVM Switch 116
1. Connect the bracket A to the sides of the Switch using the two 6mm screws
provided see figure below.
SMARTRACK 116 SWITCH
Figure 12 Taking the rear bracket out
, and for the long bracket use the flat screws
Figure 13 Inserting and tightening the medium/long bracket
Figure 14 Connecting the bracket A to the sides of the Switch
7
. See