Table of Contents
Advertisement
Axiom Pro User Guide
Edit Mode
! IMPORTANT:
If you are using Axiom Pro in HyperControl Mode, nearly all of the configuration that would normally take place
using Edit Mode (described in this chapter) happens automatically However, if your application does not support
HyperControl or if you are using Axiom Pro to control a hardware MIDI device, this section will cover all of the inner
workings of the controller
Axiom Pro has two primary modes of operation: Edit Mode and Performance Mode Most of the time, the controller stays in
Performance Mode so you can use the keyboard to control your MIDI compatible hardware and software; Edit Mode is only
used when you need to configure various parameters such as button, knob, or pad assignments or to change
keyboard-specific parameters such as the global MIDI output channel or the velocity response curve of the keys and pads
Pressing the Edit button illuminates the button and places the Axiom Pro keyboard into Edit Mode Pressing the button again
exits Edit mode and the Edit button will no longer be illuminated
Edit Mode contains a main menu and six sub-menus This chapter explains each of these six pages in detail
✓ T I P :
This section of the User Guide is written as a "reference" manual and describes every parameter and setting
on a menu-by-menu basis This is useful if you are on a specific page within Edit Mode and want to know more
about an individual parameter or setting However, if you would like to learn how to accomplish a specific
task (e g , "How do I change the MIDI assignment of an encoder knob?" or "How do I change the global MIDI
channel?") please see the "How To:" section earlier in this User Guide The "How To:" section presents tasks
in a logical fashion and provides shortcuts to the page (and parameter within that page) to help you quickly
accomplish your tasks
A note on Edit Mode navigation: There are a number of ways to select and modify the parameters contained
within Edit Mode:
To select a parameter for editing:
<
• Press Soft Keys 2 or 3
• Turn encoder knob E1
To change a parameter's setting:
<
• Turn encoder knob E5
• Use the "+" and "-" buttons on the numerical keypad (Axiom Pro 49/61 only)
Certain pages and parameters will require you to use additional encoder knobs or other controls These pages
and parameters will be discussed individually throughout the rest of this section
OR
OR
|
24
Hide quick links:
Advertisement
Table of Contents
