Edit Mode > Control - M-Audio Axiom Pro User Manual

Axiom Pro User Guide
Edit Mode > Control
The Edit Mode > Control page contains parameters relating to the operation of a specific control on Axiom Pro (i e , an individual
pad, encoder knob, button, etc )
The Control page is automatically set to modify the last item that was manipulated before entering Edit mode For example, if you
adjusted the modulation wheel prior to entering the Edit Mode > Control page, the modulation wheel will be selected for editing.
Alternatively, different groups of controllers (pads, encoders, etc ) can be selected by turning encoder knob E2 Encoder knob E3
can then be used to select the specific control (i e , the individual pad, encoder, etc ) that you would like to modify Finally, the
Axiom Pro controls (encoder knobs, pads, etc ) that can be programmed in "profiles" can be accessed by using encoder knob E4
Parameter:
Value Range:
Editing Name Parameters:
To edit the name parameter found on any of the Edit Mode pages:
Select the Name parameter and Press Soft Key 4 (Enter)
<
Use the lower row of Encoder Knobs to select letter, numbers, and characters:
<
• Turn Encoder knob E5 to select capital letters
• Turn Encoder knob E6 to select lower-case letters
• Turn Encoder knob E7 to select numbers
• Turn Encoder knob E8 to select additional characters (such as spaces, parentheses, exclamation
"Use Encoder knob E1 or Soft Keys 2 and 3 to move the editing prompt left and right
<
Once you have finished editing a Name parameter, press Soft Key 4 (Enter) to confirm your change To cancel
any changes you have made, press Soft Key 1 (Exit)
press 2
Name
(varies)
This parameter lets you name the control that is currently selected for editing
points, etc )
|
30