Section 2-Assembly; Assembling The Patient Lift; Assembling The Mast Assembly To The Base; Assembling The Knee Pad To The Mast Assembly - Invacare ROZE Owner's Manual

SECTION 2—ASSEMBLY
SECTION 2—ASSEMBLY

Assembling the Patient Lift

Assembling the Mast Assembly to the Base

NOTE: The mast assembly may be removed from the base for
storage or transporting. The mast assembly MUST be properly
secured to the base assembly before use.
NOTE: For this procedure, refer to FIGURE 2.1.
1. Put the base on a level surface so all casters make
contact with the floor.
2. Lock the rear casters (Detail "A").
3. Unscrew the top knob and remove it from the base.
4. Loosen the bottom knob, but leave it screwed into the
base.
5. Connect the mast assembly cable (not shown) to the
base cable (not shown).
6. Put the tube of the mast assembly into the hole in the
base.
7. While supporting the mast assembly, tighten the
bottom plastic knob.
8. Screw the top plastic knob into the hole in the base.
Assembling the Knee Pad to the Mast
Assembly
NOTE: For this procedure, refer to FIGURE 2.2.
NOTE: The knee pad may be removed from the patient lift for
storage or transporting. The knee pad MUST be properly secured
to the mast assembly before use.
1. Push the knee pad down into position on the knee pad
mounting bracket on the mast assembly.
2. Put the fix block in place on the knee pad mounting
bracket.
3. Insert the quick release knob through the mounting
bracket, kneed pad and fix block.
4. Tighten the quick release knob.

Assembling the Foot Plate to the Mast Assembly

NOTE: For this procedure, refer to FIGURE 2.3.
1. Rotate the foot plate up and place the hooks on the foot
plate onto the top mounting bolts in the mast assembly.
2. Rotate the foot plate down towards the mast assembly.
The bottom of the foot plate will rest against the bottom
bolts on the mast assembly.
3. Ensure that the foot plate is level and secure.
Roze™ Stand Up Patient Lift
DETAIL "A"
Push tab down
to LOCK.
Push tab UP
to UNLOCK.
FIGURE 2.1 Assembling the Mast Assembly to the Base
Knee Pad
Mounting Bracket
FIGURE 2.2 Assembling the Knee Pad to the Mast Assembly
Mast Assembly
Top Mounting
Bolt
Bottom Mounting Bolt
FIGURE 2.3 Assembling the Foot Plate to the Mast Assembly
10
Mast Assembly
Top Knob
Base
Bottom Knob
Caster
Quick Release
Knob
Knee Pad
Fix Block
Foot Rest
(shown in place)
Part No. 1150703