Putting The Vmx 200-Ii Into Operation; Charging The Headset Battery - Sennheiser VMX 200-II Instruction Manual

Putting the VMX 200-II into operation

1:20 h
10 | VMX 200-II
Putting the VMX 200-II into operation

Charging the headset battery

WARNING
Danger of injury!
Wearing the headset when charging can cause burns and injuries.
Do not wear the headset when charging.
A complete charging cycle takes about 1 hour and 20 minutes. Before
using the headset for the first time, charge the rechargeable battery for
a complete charging cycle without interruption.
A charging time of ...
approx. 10 min
approx. 20 min
approx. 40 min
approx. 60 min
approx. 80 min
1 Take off the headset and switch it off (see page 15).
2 Connect the smaller plug of the charging cable to the USB socket of the
VMX 200-II.
3 Connect the USB plug of the charging cable to the USB socket of the
power supply unit or your computer.
4 The battery is being charged.
The LED lights up red until the charge state reaches 50%. Then the LED
lights up blue until the charging cycle is complete. When the recharge-
able battery is fully charged, the LED flashes 3 times blue and then goes
off.
1
OFF
3 s
3
*
**
*
not supplied with USB version
**
only supplied with 3in1 version
When the battery level drops below 15 minutes of talk time, the LED
flashes red and you hear a low battery warning every 5 minutes. The
headset automatically switches off after the battery has dropped
below the minimum level.
corresponds to a talk time of ...
approx. 1 h 30 min
approx. 2 h 40 min
approx. 5 h 20 min
approx. 7 h 30 min
approx. 10 h
2
4
0 – 50 %
50 – 100 %
100 %
3x Off