Putting The Headset Into Operation; Charging The Headset Battery - Sennheiser MB 110 WN Instruction Manual

Putting the headset into operation

1:20 h
10 | MB 110
Putting the headset into operation

Charging the headset battery

WARNING
Danger of injury!
Wearing the headset when charging can cause burns and injuries.
Do not wear the headset when charging.
A complete charging cycle takes about 1 hour and 20 minutes. Before
using the headset for the first time, charge the rechargeable battery for a
complete charging cycle without interruption.
A charging time of ... corresponds to a battery life of ... LED flashes
approx. 10 min < 20%
approx. 20 min > 20%
approx. 40 min > 40%
approx. 60 min > 60%
1 Take off the headset and switch it off (see page 16).
2 Connect the micro USB plug of the charging cable to the USB socket of
the headset.
3 Connect the USB plug of the charging cable to the USB socket of your
computer, the car charger or a power supply unit (not included).
4 The battery is being charged. The LED flashes depending on the battery
charge level. After 5 minutes, the LED goes off. Press the multi-function
button to check the battery charge level. When the battery is fully
charged, the LED lights up blue.
1
3
*
When the battery charge level drops below 10%, the LED flashes red
and the voice prompt "recharge headset" is announced several
times. When the battery is flat, the headset switches off
automatically.
2
4
LED flashes Meaning
1x
< 20% battery left
1x
> 20% battery left
2x
> 40% battery left
3x
> 60% battery left
4x
> 80% battery left
*
not included
1x
1x
2x
3x
100 %