Strong SRT 5400 User Manual page 12

Connect AC Power Cord
Connect the C power cable of the SRT 5400 to a standard AC outlet.
POWER ON & Full SCAN
Listed below is the procedure to automatically scan to lock in all available channels.
Prior to this procedure it important to note:
In the Menu system of the SRT 5400, the default VIDEO setting is COMPONENT.
However, if you have connected by either S-Video (Y/C) or CVBS Composite, or
Component, VIDEO source will still be recognized and you will not need to alter the video
setting in the Menu System after you have completed the Automatic Scan procedure.
If you require to connect by either VGA (RGB Monitor/RGB Component) or DVI, you will
need to firstly connect by any of the other 3 Video methods listed above otherwise on first
set up of Automatic Scan, VIDEO will not be recognized.
Once Automatic Scan has been completed, Video pictures will be available thus enabling
you to select and view the Menus's to change to your Video setting of either VGA or DVI.
POWER ON the SRT 5400
Turn the SRT 5400 ON. There is an ON/OFF Switch on the rear panel of the Receiver.
(Located beside the main power cord of the receiver) The 7-segment LEDs will light
On the SRT 5400 Remote Control Press
Power LED will turn off.
Setting the Television Input Source
Press the Power On of Television Remote Control unit to turn on the television. Allow the
television to warm up. Press TV/Video button of television remote control unit to select
external video input connected to the SRT 5400.
When Power is ON, you will view a Strong Image Banner on the TV Screen for a few
seconds and banner view will then change to Press Menu Banner. Your Receiver is now
ready to be scanned to lock in all of the Broadcast Frequencies in your area.
You will see Strong Image Banner on Component, RGB mode.
STRONG HD STB User's Manual
(Page 7 No. 1) to turn on the STB. The Blue
12