Drip Pans; Lift-Up Cooktop - GE JMP31CLCC Owner's Manual

Care and cleaning of the range.
Be sure the controls are turned to OFF and the surface units are cool before attempting to remove them.
Surface unit
Drip pan
Receptacle
Support rod
Be sure all surface units are turned
off before raising the cooktop.
22
Surface Units
To clean the surface units, turn the
control to the highest setting for a
minute. The coils will burn off any soil.
To remove a surface unit:
To remove the drip pans for cleaning,
the surface units must be removed first.
Lift the surface unit about 1" above the
drip pan and pull it out.
Do not lift the surface unit more than 1". If you
do, it may not lie flat on the drip pan when you
plug it back in.
Repeated lifting of the surface unit
more than 1" above the drip pan can
permanently damage the receptacle.

Drip Pans

Remove the surface units. Then lift out
the drip pans.
For best results, clean the drip pans by
hand. Place them in a covered container
(or a plastic bag) with 1/4 cup ammonia
to loosen the soil. Then scrub with a
soap-filled scouring pad if necessary.
Rinse with clean water and polish with a
clean soft cloth.

Lift-Up Cooktop

Clean the area under the cooktop often. Built-up
soil, especially grease, may catch fire.
To make cleaning easier, the entire
cooktop may be lifted up and supported
in the up position.
Be sure all the surface units are turned
off before raising the cooktop. The
surface units and drip pans do not need
to be removed; however, you may remove
one to make raising the cooktop easier.
A support rod will hold the cooktop up
while you clean underneath it.
To replace a surface unit:
Replace the drip pan into the recess in
the cooktop. Make sure the opening in
the pan lines up with the receptacle.
Insert the terminals of the surface unit
through the opening in the drip pan and
into the receptacle.
Guide the surface unit into place so it
rests evenly.
Do not immerse the surface units in liquids of
any kind.
Do not clean the surface units in a dishwasher.
Do not bend the surface unit plug terminals.
Do not attempt to clean, adjust or in any way
repair the plug-in receptacle.
The drip pans may also be cleaned in
a dishwasher.
Clean the area under the drip pans
often. Built-up soil, especially grease,
may catch fire.
Do not cover the drip pans with foil. Using foil so
close to the receptacle could cause shock, fire or
damage to the range.
After cleaning under the cooktop with
hot, soapy water and a clean cloth, lower
the cooktop. Be careful not to pinch your
fingers.