GE JMP31CLCC Owner's Manual page 25

Problem
"LOCK DOOR" flashes
in the display
LOCKED DOOR light
is on when you want
to cook
"F— and a number
or letter" flash in
the display
Display goes blank
Display flashes
Unable to get the
display to show "SF"
Power outage,
clock flashes
"Burning" or "oily"
odor emitting from
the vent
Strong odor
Fan noise
Possible Causes
The self-clean cycle has been • Close the oven door.
selected but the door is not
closed.
The oven door is locked
because the temperature
inside the oven has not
dropped below the
locking temperature.
You have a function
error code.
If the function code repeats.
A fuse in your home may be
blown or the circuit
breaker tripped.
The clock is in the
black-out mode.
Power failure.
Oven control pads were
not pressed properly.
Power outage or surge.
This is normal in a new oven • To speed the process, set a self-clean cycle for a
and will disappear in time.
An odor from the insulation
around the inside of the
oven is normal for the first
few times the oven is used.
A cooling fan may
automatically turn on and
off to cool internal parts.
What To Do
• Press the CLEAR/OFF pad. Allow the oven to cool.
• Press the CLEAR/OFF pad. Allow the oven to cool for one
hour. Put the oven back into operation.
• Disconnect all power to the range for at least 30
seconds and then reconnect power. If the function
error code repeats, call for service.
• Replace the fuse or reset the circuit breaker.
• See the Special features of your oven control section.
• Reset the clock.
• The BAKE and BROIL HI/LO pads must be pressed
at the same time and held for 3 seconds.
• Reset the clock. If the oven was in use, you must reset
it by pressing the CLEAR/OFF pad, setting the clock
and resetting any cooking function.
minimum of 3 hours. See the Using the self-cleaning
oven section.
• This is temporary.
• This is normal. The cooling fan will turn off and on.
ge.com
25