Table of Contents
Advertisement
OVEN CONTROL, CLOCK AND TIMER
Clock
The clock must be set for the
automatic oven timing functions to
work properly. The time of day
cannot be changed during a TIME
BAKE or CLEAN cycle.
Timer
The timer is an alarm or minute
timer only. The timer does not
control oven operations. The
maximum setting on the timer is
9 hours and 55 minutes.
To Reset Timer
Press TIMER pad and then press
INCREASE or DECREASE pad
until the time you want shows on
the display.
Timer Tones
The timer tone is three short beeps followed by
1 beep that repeats every six seconds until you press
any operation. If you would like to eliminate the
repeating beeps, press and hold the CLEAR/OFF pad
for 10 seconds.
To return the timer tone to the repeating beeps, press
and hold the CLEAIUOFF pad for 10 seconds.
14
To Set the Clock
Step 1: Press the
CLOCK pad.
CLOCK
c1
To Set the Timer
Step 1: Press the
1
TIMER pad.
TIMER
Step 2: Press INCREASE or
DECREASE pad to set the amount
of time on timer.
To Cancel Timer
Press TIMER pad until the word
"TIMER" quits flashing on the
display (about 4 seconds).
Display Messages
If "door" appears on the display, the door is not
closed. lf "LOCK" appears on the display, the oven
door is in the locked position. BAKE, BROIL and
COOK TIME cannot be set if the door is in the
locked position.
Step 2: Press
1
INCREASE or
A
DECREASE pad to
set the time of day.
Step 3: Press the CLOCK pad
to start.
The timer will start automatically
within a few seconds of releasing
the pad.
The timer, as you are setting it,
will display seconds until 1 minute
is reached.
Then it will display minutes
and seconds until 10 minutes
is reached.
After 10 minutes, it will display
hours ("HR" now appears in
display) and minutes until the
maximum time of 9 hours and
55 minutes is reached.
Power Outage?
After a power outage, when power
is restored, the display will flash
and time shown will no longer be
correct-for example, after a
5-minute power interruption the
clock will be 5 minutes slow.
The display flashes until the clock
is reset. All other functions that
were in operation when the power
went out will have to be
programmed again.
Advertisement
Table of Contents
