To Cancel The Timer; Display Messages; Power Outage - GE JGSP30GER Use And Care Manual

OVEN CONTROL CLOCK Am TMER
Clock
The clock must be set for the
automat ic oven timing functions to
work properly. The time of day
Bake or CLEAN cycle.
Timer
The timer is a minute timer only.
The timer does not control oven
operations. The mtiximum setting
on the timer is 9 hours tind
55 minutes.
To Reset the Timer
If "TIMER" is showing, press the
INCREASE or DECREASE pad
until desired time is reached.
the TIMER pud first, then follow
instructions tibovc to set the timer.

Display Messages

If "DOOr" appears on the display, the door is open.
Close the door. [f .'LOCK" appears on the display. the
oven door is in the locked position. BAKE, BROIL
and COOK TIME c~nnol be set if the door is in the
locked position.
To Set the Clock
To Set the Timer
Step 1: Press the
1
TIMER pad.
T I M E R
Step 2: Press the INCREASE or
DECREASE pad to set the amount
of time on timer.

To Cancel the Timer

Press the TIMER p~d until the
word "TINIER" quits tlashing on
the displtiy (Jbout 4 seconds).
End of Cycle Tone
The end of cycle tone is a series of three beeps
followed by one beep every six seconds. If
like to remove the signal that beeps every six seconds,
press and hold the CLEAR/OFF pad for 10 seconds.
To return the signal that beeps every six seconds,
press and hold the CLEAR/OFF pad for I () seconds.
INCREASE or
DECREASE pad
set the time of day.
Step 3: Press the CLOCK pad
to start.
The timer will sttirt automtitically
within a few seconds of releasing
the pad.
The timer, as you are setting
it, wil I display seconds until
60 seconds is reached.
Then it will display minutes
and seconds until 60 minutes
is reached.
After 60 minutes, it will display
hours ("HR" now appears in
display) and minutes until the
maximum time of 9 hours and
55 minutes is reached.

Power Outage?

After a power outage, when power
is restored, the display will tlash
and time shown will no longer be
correct-for example, after a
5-minute power interruption the
clock will be 5 minutes slow.
The the clock
-
is reset. All other functions that
were in operation when the power
went out will have to be
programmed again.
YOU
to
9