Drip Pans; Oven Door - GE JGSP20GER Use And Care Manual

Drip Pans

Remove the grates. Then lift out the chrome drip
pans. Wash them in hot, soapy water. Rinse them with
clean, hot water and polish them dry with a cloth.
Never use abrasive cleansers or steel wool—they'll
scratch the surface. Instead, soak the drip pans for
about 20 minutes in slightly diluted liquid cleanser or
mild solution of ammonia and water (1/2 cup of
ammonia to one gallon of water). After soaking, wash
them in hot, soapy water. Rinse with clean water and
polish with a clean, soft cloth.

Oven Door

The oven door is removable to make the interior
more accessible.
To remove the door.
open it a few inches
to the special stop
position that will hold
the door open. Grasp
firmly on each side
and lift the door
straight up and off the
hinges. Do not use
the door handle to lift
the door.
NOTE: Be careful not to place hands between the
spring hinge and the oven frame as the spring hinge
could snap back and pinch your fingers.
TO CLEAN THE DOOR:
Inside of door: Clean ONLY the door liner outside
the gasket with soap and water. The door is automatically
cleaned if the oven is in the self-cleaning cycle. Do
not rub or damage the gasket. Avoid getting soap
and water on the gasket or in any openings on the
door. Rinse well. NOTE: Soap left on liner causes
additional stains when the oven is reheated.
&~
'1
Do not attempt to clean the drip pans in the
self-cleaning oven.
When replacing drip pans, the notch on the rear
pan and the notch on the front pan should meet in
the middle.
Outside of door: Use soap and water to thoroughly
clean the top, sides and front of the oven door. DO
NOT let water run down through openings in the top
of the door. Rinse well.
Spillage of marinades, fruit juices, tomato sauces and
basting materials containing acids may cause
discoloration and should be wiped up immediately.
Take care not to touch hot portion of the oven. When
surface is cool, clean and rinse.
Do not use oven cleanser, cleansing powders or
harsh abrasives.
To replace the door, make sure the hinges are in the
"out" position. Position the slots in the bottom of the
door squarely over the hinges. Then lower the door
slowly and evenly over both hinges at the same time.
If hinges snap back against the oven frame, pull them
back out.
(con finL{efl next p~rge)
29