Display Messages - GE JGBP31GEP Use And Care & Installation Manual

Clock
The clock must be set for the
automatic oven timing functions to
work properly. The time of day
cannot be changed during a Timed
Bake or CLEAN cycle.
Timer
The timer is a minute timer; it does
not control oven operations. The
maximum setting on the timer is 9
hours and 55 minutes.
To Reset Timer
If "TIMER" is showing, press the
INCREASE or DECREASE pad
until desired time is reached.
If "TIMER" is not showing, press
the TIMER pad first, then follow
instructions above to set the timer.
End of Cycle Tones
The end of cycle tone is a series of three beeps
followed by one beep every six seconds. If you would
like to remove the signal that beeps every six seconds,
press and hold the CLEAWOFF pad for 10 seconds.
To return the signal that beeps every six seconds,
press and hold the CLEAWOFF pad for 10 seconds.
To Set the Clock
1. Press the
CLOCK pad.
CLOCK
To Set the Timer
1. Press the pad.
TIMER
o
2. Press the INCREASE or
DECREASE pad to set the
amount of time on timer.
To Cancel Timer
Press TIMER pad until the word
"TIMER" quits flashing on the
display (about 4 seconds).

Display Messages

If "DOOr" appears on the display, the door latch
handle is not moved all the way to the right. Move the
latch handle and cleaning will start. If "LOCK"
appears on the display, the oven door is in the locked
position. BA~, BROIL and COOK TIME cannot be
set if the door is in the locked position.
INCREASE or
A
DECREASE pad
to set the time
of day.
3. Press the CLOCK pad
to start.
The timer will start automatically
within a few seconds of releasing
the pad.
The timer, as you are setting it,
will display seconds until 60
seconds is reached.
Then it will display minutes
and seconds until 60 minutes
is reached.
After 60 minutes, it will display
hours ("HR" now appears in
display) and minutes until the
maximum time of 9 hours and
55 minutes is reached.
Power Outage?
After a power outage, when power
is restored, the display will flash
and time shown will no longer be
correct-for example, after a
5-minute power interruption the
clock will be 5 minutes slow.
The display flashes until the clock
is reset. All other functions that
were in operation when the power
went out will have to be
programmed again.
11