To Cancel The Timer; Power Outage; Display Messages - GE JBP80 Use And Care & Installation Manual

Clock
The clock must be set for the
automatic oven timing functions to
work properly. The time of day
cannot be changed during a Timed
Baking or CLEAN cycle.
Timer
The timer is a minute timer; it does
not control oven operations. The
maximum setting on the timer is
To Reset the Timer
INCREASE or DECREASE pad until desired time
is reached.
If only "TIMER" is displayed, press the TIMER pad
first, then follow the instructions above to set the timer.
End of Cycle Tones
The end of cycle tone is a series of 3 beeps followed
by 1 beep every 6 seconds. If you would like to
remove the signal that beeps every 6 seconds. press
and hold the CLEAIVOFF pad for 10 seconds.
To return the signal that beeps every 6 seconds, press
and hold the CLEAR/OFF pad for 10 seconds.

Display Messages

programmed information can be
displayed at any time by pressing
the pad of the operation you want
to see. For example. you can
display the current time of day
while the timer is counting down
by pressing the CLOCK pad. Press
the TIMER pad to return to the
timer display.
To Set the Clock
CLOCK
To Set the Timer
TIMER pad.
TIMER
2. Press the INCREASE or
DECREASE pad to set the
amount of time on the timer.

To Cancel the Timer

Press and hold the TIMER pad until the word
"TIMER" disappears from the display.

Power Outage

After a power outage, when power is restored, the
display will flash and time shown will no longer be
correct-for example, after a 5-minute power
interruption the clock will be 5 minutes slow.
All other functions that were in operation when the
power went out will have to be programmed again.
To check the start time for Delayed
Bake or Self-Clean, press and hold
the COOK TIME or AUTO SELF
CLEAN pad for 3 seconds. The
display will show the bake or clean
start time for as long as you press
the pad. When you release the pad,
the display will return to the time
of day.
2. Press the INCREASE or
DECREASE pad to set the
-
time of day.
3. Press the CLOCK pad to start.
The timer will start automatically
within a few seconds of releasing
the INCREASE or DECREASE pad.
The timer, as you are setting it,
will display hours and minutes.
"HR" will be in the display.
During the countdown, when the
timer reaches the last minute, the
display will change to seconds
only and a single beep will sound.
If "door" appears in the display,
LOCK flashes, and the oven
control signals you set the self-
clean cycle and did not shut the
oven door.
19