Nylon; M10 Nylon; Assembly - Weider Club C650 Bench User Manual

ASSEMBLY

Make Assembly Easier
Everything in this manual is designed to ensure
that the weight bench can be assembled suc-
cessfully by almost anyone. By setting aside
plenty of time, assembly will go smoothly.
Before beginning assembly, carefully read the fol-
lowing information and instructions:
• To hire an authorized service technician to
assemble the weight bench, call 1-800-445-2480.
• Assembly requires two persons.
• Because of its size, the weight bench should be
assembled in the location where it will be used.
Make sure that there is enough clearance to walk
around the weight bench as you assemble it.
• Tighten all parts as you assemble them, unless
instructed to do otherwise.
1.
Before beginning assembly, make sure you
understand the information in the box
above.
Attach a Large Base Cap (70) to the Left Base
(40) with two M4 x 16mm Screws (36). Attach
another Large Base Cap to the other end of
the Left Base in the same way.
Orient the Center Base (39) so that the warning
decals are in the positions shown. Attach the Left
Base (40) to the Center Base with two M10 x
78mm Bolts (32) and two M10 Nylon Locknuts
(34). Do not tighten the Nylon Locknuts yet.
Repeat this step with the Right Base (not
shown).
Insert two M10 x 75m Carriage Bolts (90) up
through the Center Base (39).
• Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until assembly is completed.
• As you assemble the weight bench, make sure all
parts are oriented as shown in the drawings.
• For help identifying small parts, use the PART
IDENTIFICATION CHART on page 5.
• Assembly requires the included hex key(s)
and the following tools (not included):
two adjustable wrenches
one rubber mallet
one standard screwdriver
one Phillips screwdriver
Assembly may be more convenient if you have a
socket set, a set of open-end or closed-end
wrenches, or a set of ratchet wrenches.
1
Warning
Decal
39
90
70
40
36
7
Warning
Decal
34
32
70