M10 X 58Mm Carriage - Weider Club C650 Bench User Manual

30. Wrap the Long Cable (68) over a Pulley (87).
Attach the Pulley, a Small Cable Trap (88), and
two Half Pulley Guards (109) to the second set of
holes from the bottom of the Pulley Plates (82)
with an M10 x 48mm Bolt (33) and an M10 Nylon
Locknut (34). Make sure that the Cable Trap is
oriented to hold the Cable in the groove of the
Pulley.
31. Attach the Long Cable (68) inside the Weight
Carriage Base (41) with an M10 x 75mm Bolt
(92), two M10 Washers (35), two 28mm Spacers
(91), and an M10 Nylon Locknut (34).
32. Attach a Small Base Cap (20) to the Bench Base
(3) with two M4 x 16mm Screws (36). Attach
another Small Base Cap (20) to the Bench
Base in the same way.
Attach the Bench Leg (4) to the Bench Base (3)
with four M10 x 68mm Bolts (98), two Leg Plates
(25), and four M10 Nylon Locknuts (34). Do not
tighten the Nylon Locknuts yet.
33. Attach a Small Base Cap (20) to the Stabilizer (2)
with two M4 x 16mm Screws (36). Attach anoth-
er Small Base Cap (20) to the Stabilizer in the
same way.
Attach the Bench Frame (1) to the Stabilizer (2)
with two M10 x 58mm Carriage Bolts (77) and
two M10 Nylon Locknuts (34). Do not tighten the
Nylon Locknuts yet.
30
109
34
87
31
34
35
32
20
98
98
20
33
20
17
82
109
33
88
68
68
91
41
91
35
92
4
3
25
25
36
34
1
2
77
36
34
20