Wall Display - DAVIS Vantage Pro Console Manual

Wall Display

1. Hold the template provided on page 17 flat against the wall and use a pencil to mark
the location of the two keyholes.
If you are installing a standard Vantage Pro console with sensor cable run-
ning inside the wall, attach the console over an empty switch box.
2. Use an electric drill with a 3/32 or 7/64" drill bit to make pilot holes in these locations.
3. Using a screwdriver, drive the two #6 x 1" pan head self-threading screws into the
wall. Leave at least 1/8" between the wall the the heads of the screws.
4. Retract the kickstand into its upright and locked position.
5. Slide the keyholes on the back of the console over the two screw heads.
Vantage Pro Manual
O
PENING THE STAND FOR TABLE OR SHELF DISPLAY
Displaying the Console
Page 15