Wall Display - DAVIS Vantage Pro User Manual & Setup Manual

Vantage Pro Console Installation

Wall Display

1. Hold the template provided here flat against the wall and use a pencil to mark the
location of the two keyholes.
If you are installing a standard Vantage Pro console with sensor cable run-
ning inside the wall, attach the console over an empty switch box.
<!-- get dimensions and make template --!>
2. Use an electric drill with a #29 (.136" or 3.5mm) drill bit to make pilot holes in these
locations.
3. Using a screwdriver, drive the two #8 x 3/4" pan head self-threading screws into the
wall. Leave at least 1/8" between the wall the the heads of the screws.
4. Retract the kickstand into its upright and locked position.
5. Slide the keyholes on the back of the console over the two screw heads.
Page 16
A
FFIXING TO A WALL
Vantage Pro Manual