Initializing The System; System Features Learn Routine - Hornet 700J Installation Manual

Table of Contents

NOTE: When adjusting the sensor, it must be mounted in the same location where it will be

after the installation is complete. Adjusting the sensor and then relocating the module may

require readjustment.

initializing the system

Before initializing the databus interface module, make sure that the power, ground, ignition and the databus

input wires are connected to the vehicle.

1. Cycle the ignition key on and then back off again.

2. Close all the vehicle doors.

3. Cycle the doors and trunk using the first OEM transmitter.

4. Repeat the door and trunk cycle for each transmitter programmed to the OEM keyless entry.

The System Features Learn Routine dictates how the unit operates. It is possible to access and change any of the

feature settings using the Valet/program switch.

To enter the System Features Learn Routine:

Open a door.

Key. Turn the ignition on, and then off. (The H1/9 YELLOW wire must be connected.)

Select a feature: Press and release the Valet/program switch the number of times corre-

sponding to the feature you wish to program. (See the following table of features.) For

example, to access the third feature, press and release three times. Then press the button

once more and HOLD it. The siren will chirp the number of times corresponding to the

feature you have accessed.

Table of Contents