PART IDENTIFICATION CHART
Use the drawings below to identify the small parts needed for assembly. The number in parentheses below each
drawing is the key number of the part, from the PART LIST near the end of this manual. The number following the
key number is the quantity needed for assembly. Note: If a part is not in the hardware kit, check to see if it
has been preassembled. To avoid damaging parts, do not use power tools for assembly.
M8 Split
Washer (75)–8
M8 x 16mm
Screw (74)–8
M8 Washer
(43)–2
M6 x 60mm Bolt Set (51)–1
M6 x 70mm Bolt Set (50)–1
M10 x 95mm Screw
5
M4 x 5mm
Bright Screw
(91)–1
(76)–4
M4 x 16mm
Screw
(90)–8