NordicTrack Grt380 User Manual page 9

8. Press a 25mm Bushing (31) into each end of the
Locking Bar (20).
Insert the Barbell (21) through the Locking Bar (20)
until the Barbell is centered in the Locking Bar.
9. Identify the Left Weight Glider (18) by looking at the
position of the round tube.
Press a 38mm Bushing (16) into each end of the
round tube on the Left Weight Glider (18). Press two
45mm x 45mm Bushings (32) into the Left Weight
Glider.
Slide the Left Weight Glider (18) onto the left end of
the Barbell (21). Secure the Weight Glider to the
Barbell with a M8 x 20mm Screw (33). Do not tight-
en the Screw.
Look at the drawing on page 4 to make sure that
you have correctly identified the left end. The Left
Weight Glider must be turned as shown in the
drawing.
10. Press a 38mm Bushing (16) into each end of the
round tube on the Right Weight Glider (17). Press two
45mm x 45mm Bushings (32) into the Right Weight
Glider.
Slide the Right Weight Glider (17) onto the right end
of the Barbell (21). Secure the Weight Glider to the
Barbell with a M8 x 20mm Screw (33). Do not tight-
en the Screw. Make sure that the Weight Glider is
turned as shown in the drawing.
11. Identify the left Safety Spotter (14) by the position of
the handle on the Left Spotter Hook (24). Place the
left Safety Spotter on the Left Base (8) so it is cen-
tered over the indicated hole.
Have a second person hold the Locking Bar (20) so
that the Left Weight Glider (18) rests on top of the left
Safety Spotter (14). Insert a Weight Guide (11) into
the Left Weight Glider, the left Safety Spotter, and the
hole in the Left Base (8). Note: Tilt the Weight
Guide away from the Upright (1) as you insert it.
Attach the Weight Guide (11) to the Left Base (8) with
an M10 x 65mm Bolt (26), two M10 Washers (3), and
an M10 Nylon Locknut (7). Do not tighten the Nylon
Locknut yet.
8
31
9
21
10
32
16
Round
17
tube
32
11
11
20
18
Handle
14
7
3
9
20
31
32
18
16
33
32
Round Tube
33
16
21
1
24
8
Hole
26
21
16