Changing The Fuses Of Individual Power Consumers - KTM 450 EXC EU Owner's Manual

ELECTRICAL SYSTEM

Changing the fuses of individual power consumers

13.5
Info
The fuse box containing the fuses of individual power consumers is located under the seat.
–
Remove screw
101395-10
–
Lift rear fairing
101396-10
–
Remove protection caps
–
Remove the faulty main fuse
Info
A defective fuse can be identified by the burned-out fuse wire
A reserve fuse
–
Install a new main fuse.
Fuse (58011109120) (
101397-10
–
Check that the electrical equipment is functioning properly.
Tip
Insert the spare fuse so that it is available if needed.
–
Mount the protection caps.
–
Mount the starter relay onto the bracket and lay the cable.
–
Position the rear fairing. Mount and tighten the screw.
Guideline
Remaining screws, chassis
–
Install the air filter box lid. (
–
Switch off all power consumers and switch off the engine.
–
Remove the seat. (
–
Open fuse box cover
101398-10
.

slightly and pull starter relay

.

.

is located in the starter relay.

p. 107)
M6
p. 52)
p. 52)
.

out of the bracket.

.

10 Nm (7.4 lbf ft)
81