Adjusting The Basic Position Of The Hand Brake Lever - KTM 690 DUKE EU Owner's Manual

12 BRAKE SYSTEM
12.2

Adjusting the basic position of the hand brake lever

ABS warning lamp
ing off. If it does not go out after starting off or if it lights up while riding, this indicates
a fault in the ABS system. In this case, the ABS is no longer enabled and the wheels may
lock during braking. The brake system itself stays functional; only ABS control is not avail-
able.
The ABS warning lamp may also light up if the rotating speeds of the front and rear wheels
differ greatly under extreme riding conditions, for example when making wheelies or if the
rear wheel spins. This causes the ABS to switch off.
To reenable the ABS, the vehicle must be stopped and the ignition switched off. The ABS
is reenabled when the vehicle is switched on again. The ABS warning lamp goes out when
you start off.
Button can be used to switch ABS off manually (see Starting).
4
(Duke)
–
Adjust the basic position of the hand brake lever to your hand size by turning
adjusting wheel
602570-11
must light up after the ignition is switched on and go out after start-
3
.
1
Info
Pull the hand brake lever forward and turn the adjusting wheel.
Do not make any adjustments while riding.
90