GE JKP18 Owner's Manual page 8

Special features of your oven control.
+
+
+
8
Tones at the End of a Timed Cycle
At the end of a timed cycle, 3 short beeps will
sound followed by one beep every 6 seconds until
the CLEAR/OFF pad is pressed. This continuous
6 second beep may be canceled.
To cancel the 6 second beep:
Press the BAKE and BROIL HI/LO
pads (on double oven models use
the upper oven controls) at the same
time for 3 seconds until the display
shows SF.
Fahrenheit or Celsius Temperature Selection
Your oven control is set to use the Fahrenheit
temperature selections but you may change this
to use the Celsius selections.
Press the BAKE and BROIL HI/LO
pads (on double oven models use
the upper oven controls) at the same
time for 3 seconds until the display
shows SF.
Cook and Hold
Your new control has a cook and hold feature that
keeps cooked foods warm for up to 3 hours after
the cooking function is finished.
To activate this feature, follow the steps
below.
On double oven models both ovens
follow the same step 1. Then proceed
with steps 2 through 3, using the pads for
the upper or lower oven.
Press the BAKE and BROIL HI/LO
pads (on double oven models use
the upper oven controls) at the same
Using Convection Conversion
By using the Convection Conversion feature you
can automatically convert the oven temperature
from regular baking to Convection Bake
temperatures.
To convert the oven temperature for
convection baking, follow the steps below.
Press and hold the CONVECTION
BAKE pad for 4 to 5 seconds.
CON Con Bake will show in the
display.
Using the number pads, enter
the temperature recommended
in the recipe.
Press the KITCHEN TIMER ON/OFF
pad. The display shows CON BEEP
(continuous beep). Press the
KITCHEN TIMER ON/OFF pad
again. The display shows BEEP.
(This cancels the one beep every
6 seconds.)
Press the START pad.
NOTE: On double oven models this cancels the
end of cycle tone for both ovens.
Press the BROIL HI/LO pad. The
display will show F (Fahrenheit).
Press the BROIL HI/LO pad again.
The display will show C (Celsius).
Press the START pad.
NOTE: On double oven models the new setting
will be displayed for both ovens.
time for 3 seconds until the display
shows SF.
Press the COOKING TIME pad. The
display will show Hld OFF.
Press the COOKING TIME pad again
to activate the feature. The display
will show Hld ON.
Press the START pad to activate
the cook and hold feature and
leave the control set in this special
features mode.
Press the START pad.
The display shows the converted
(reduced) temperature. For
example, if you entered a recipe
temperature of 350°F., the display
will show 325°F. when it is converted.
Press the CLEAR/OFF pad when
baking is finished.
NOTE: Conversion must be set each time you
want to use it. It is not held in memory.