Commands - Seagate ST500LM000 Product Manual

5.3.3 S.M.A.R.T. commands
S.M.A.R.T. provides near-term failure prediction for disk drives. When S.M.A.R.T. is enabled, the drive monitors
predetermined drive attributes that are susceptible to degradation over time. If self-monitoring determines that a failure is
likely, S.M.A.R.T. makes a status report available to the host. Not all failures are predictable. S.M.A.R.T. predictability is
limited to the attributes the drive can monitor. For more information on S.M.A.R.T. commands and implementation, see the
Draft ATA-5 Standard.
SeaTools diagnostic software activates a built-in drive self-test (DST S.M.A.R.T. command for D4
unnecessary drive returns. The diagnostic software ships with all new drives and is also available at:
http://www.seagate.com/support/downloads/seatools/.
This drive is shipped with S.M.A.R.T. features disabled. You must have a recent BIOS or software package that supports
S.M.A.R.T. to enable this feature. The table below shows the S.M.A.R.T. command codes that the drive uses.
Table 13 S.M.A.R.T. Commands
C
ODE IN FEATURES REGISTER
D0
H
D2
H
D3
H
D4
H
D5
H
D6
H
D8
H
D9
H
DA
H
If an appropriate code is not written to the Features Register, the
N
OTE
command is aborted and 0x 04 (abort) is written to the Error register.
S L T SSHD SATA P
EAGATE APTOP HIN
S.M.A.R.T.
COMMAND
S.M.A.R.T. Read Data
S.M.A.R.T. Enable/Disable Attribute Autosave
S.M.A.R.T. Save Attribute Values
S.M.A.R.T. Execute Off-line Immediate (runs DST)
S.M.A.R.T. Read Log Sector
S.M.A.R.T. Write Log Sector
S.M.A.R.T. Enable Operations
S.M.A.R.T. Disable Operations
S.M.A.R.T. Return Status
M , R
RODUCT ANUAL EV
. D
S ATA (SATA) I
ERIAL NTERFACE
) that eliminates
H
28