Table of Contents
Advertisement
www.seagate.com
Notes:
1. All pins are in a single row, with a 1.27mm (0.050") pitch.
2. The comments on the mating sequence apply to the case of backplane blindmate connector only. In this
case, the mating sequences are:
• the ground pins P4 and P12.
• the pre-charge power pins and the other ground pins.
• the signal pins and the rest of the power pins.
3. There are three power pins for each voltage. One pin from each voltage is used for pre-charge when installed
in a blind-mate backplane configuration.
4. All used voltage pins (V
4.3 Supported ATA commands
The following table lists Serial ATA standard commands that the drive supports.
For a detailed description of the ATA commands, refer to the Serial ATA International Organization:
Serial ATA Revision 3.0 (http://www.sata-io.org).
See "S.M.A.R.T. commands" on page 30.for details and subcommands used in the S.M.A.R.T. implementation.
Table 6 Supported ATA commands
Command name
Check Power Mode
Configure Stream
Device Configuration Freeze Lock
Device Configuration Identify
Device Configuration Restore
Device Configuration Set
Device Reset
Download Microcode
Execute Device Diagnostics
Flush Cache
Flush Cache Extended
Format Track
Identify Device
Idle
Idle Immediate
Initialize Device Parameters
Read Buffer
Read DMA
Read DMA Extended
Read DMA Without Retries
Read FPDMA Queued
Pipeline HD Product Manual, Rev. A
) must be terminated.
x
Command code (in hex)
E5
H
51
H
B1
/ C1
H
B1
/ C2
H
B1
/ C0
H
B1
/ C3
H
08
H
92
H
90
H
E7
H
EA
H
50
H
EC
H
E3
H
E1
H
91
H
E4
H
C8
H
25
H
C9
H
60
H
H
H
H
H
22
Advertisement
Table of Contents
