Subscribe to Our Youtube Channel
Related Manuals for Seagate ST500LX005
Summary of Contents for Seagate ST500LX005
- Page 1 Laptop Thin SSHD SATA Product Manual Standard models Self-Encrypting Drive models ST500LX005 ST500LM001 ST500LX007 SED (FIPS 140-2) ST500LM000 models ST320LM002 ST500LM020 100716628, Rev. J Gen 1 August 2015...
- Page 2 Publication number: 100716628, Rev. J August 2015 Seagate, Seagate Technology and the Spiral logo are registered trademarks of Seagate Technology LLC in the United States and/or other countries. 3D Defense System and SeaTools are either trademarks or registered trademarks of Seagate Technology LLC or one of its affiliated companies in the United States and/or other countries.
-
Page 3: Table Of Contents
Seagate® Technology Support Services ........ - Page 4 S.M.A.R.T. commands ..........32 Seagate Laptop Thin SSHD SATA Product Manual, Rev. J...
- Page 5 Example of FIPS tamper evidence labels........22 Seagate Laptop Thin SSHD SATA Product Manual, Rev. J...
-
Page 6: Seagate® Technology Support Services
Authorized Service Centers For information regarding Warranty Support, visit: http://www.seagate.com/support/warranty-and-replacements/ For information regarding data recovery services, visit: http://www.seagate.com/services-software/data-recovery-services/ For Seagate OEM and Distribution partner portal, visit: http://www.seagate.com/partners/ For Seagate reseller portal, visit: http://www.seagate.com/partners/my-spp-dashboard/ Seagate Laptop Thin SSHD SATA Product Manual, Rev. J... -
Page 7: Introduction
Introduction ® This manual describes the functional, mechanical and interface specifications for the following Seagate Laptop Thin SSHD model drives: Standard models Standard SED models SED (FIPS 140-2) models ST500LX005 ST500LM000 ST500LM001 ST500LM020 ST500LX007 ST320LM002 Previous generations of Seagate Self-Encrypting Drive models were called... -
Page 8: About The Serial Ata Interface
Shadow Register Block. All Serial ATA devices behave like Device 0 devices. For additional information about how Serial ATA emulates parallel ATA, refer to the Serial ATA International Organization: Serial ATA (Revision 2.6). The specification can be downloaded from www.serialata.org Seagate Laptop Thin SSHD SATA Product Manual, Rev. J... -
Page 9: Drive Specifications
35°C per hour max (nonoperating) 5% to 95% (operating) Relative humidity 5% to 95% (nonoperating) Relative humidity gradient 30% per hour max 37.7°C max (operating) Wet bulb temperature (max) 40.0°C max (nonoperating) Seagate Laptop Thin SSHD SATA Product Manual, Rev. J... -
Page 10: Formatted Capacity
Refer to on page 19 (words 60-61 and 100-103) for additional information about 48-bit Configuring and Mounting the Drive addressing support of drives with capacities over 137 GB. Seagate Laptop Thin SSHD SATA Product Manual, Rev. J... -
Page 11: Physical Organization
However, due to the manner in which these drives are formatted, benchmark tests that include Note command overhead or measure logical seeks may produce results that vary from these specifications. Seagate Laptop Thin SSHD SATA Product Manual, Rev. J... -
Page 12: Start/Stop Times
Idle mode power is measured with the drive up to speed, with servo electronics active and with the heads in a random track location. Standby mode During standby mode, the drive accepts commands, but the drive is not spinning, and the servo and read/write electronics are in power-down mode. Seagate Laptop Thin SSHD SATA Product Manual, Rev. J... -
Page 13: Figure 1 Typical 5V Startup And Operation Current Profile
Standby power is measured at steady state (after 200ms from transition) 2.7.1.1 Typical current profiles The typical 5V startup and operation current profile is shown in Figure 1 Figure 1 Typical 5V Startup and Operation Current Profile Seagate Laptop Thin SSHD SATA Product Manual, Rev. J... -
Page 14: Conducted Noise
If the standby timer reaches zero before any drive activity is required, the drive makes a transition to standby mode. In both Idle and standby mode, the drive accepts all commands and returns to active mode when disk access is necessary. Seagate Laptop Thin SSHD SATA Product Manual, Rev. J... -
Page 15: Environmental Specifications
Drive Specifications Environmental Specifications This section provides the temperature, humidity, shock, and vibration specifications for Seagate Laptop Thin SSHD drives. Ambient temperature is defined as the temperature of the environment immediately surrounding the drive. Above 1000 feet (305 meters), the maximum temperature is derated linearly by 1°C every 1000 feet. -
Page 16: Acoustics
Seagate follows the ECMA-74 standards for measurement and identification of PDTs. An exception to this process is the use of the absolute threshold of hearing. Seagate uses the lower limit for the threshold curve* to discern tone audibility and to compensate for the inaudible components of sound prior to computation of tone ratios according to Annex D of the ECMA-74 standards. -
Page 17: Reliability
EN 55024. Drives are tested in representative end-user systems. Although CE-marked Seagate drives comply with the directives when used in the test systems, we cannot guarantee that all systems will comply with the directives. The drive is designed for operation inside a properly designed enclosure, with properly shielded I/O cable (if necessary) and terminators on all unused I/O ports. -
Page 18: 2.12.3 Fcc Verification
As a subassembly, no Federal Communications Commission verification or certification of the device is required. Seagate has tested this device in enclosures as described above to ensure that the total assembly (enclosure, disk drive, motherboard, power supply, etc.) does comply with the limits for a Class B computing device, pursuant to Subpart J, Part 15 of the FCC rules. -
Page 19: Environmental Protection
The silver, copper, nickel and gold films used in Seagate products are especially sensitive to the presence of sulfide, chloride, and nitrate contaminants. Sulfur is found to be the most damaging. In addition, electronic components should never be exposed to condensing water on the surface of the printed circuit board assembly (PCBA) or exposed to an ambient relative humidity greater than 95%. -
Page 20: Configuring And Mounting The Drive
Figure 2 Attaching SATA Cabling Signal connector Power connector Signal cable Power cable Each cable is keyed to ensure correct orientation. Seagate Laptop Thin SSHD SATA drives support latching SATA connectors. Seagate Laptop Thin SSHD SATA Product Manual, Rev. J... -
Page 21: Drive Mounting
3.567 in 5.84 mm 90.60 mm .551 in 13.99 mm .263 in 6.68 mm 2.430 in 61.72 mm .160 in 4.06 mm For reference only. May not represent actual drive. Note Seagate Laptop Thin SSHD SATA Product Manual, Rev. J... -
Page 22: Figure 4 Mounting Dimensions (For Fips 140-2 Models)
These stickers must remain attached to provide the tamper evidence throughout the life of the drive. Note May not represent actual labels.) Removing these stickers will indicate tampering and void the drive warranty. ( Seagate Laptop Thin SSHD SATA Product Manual, Rev. J... -
Page 23: About Fips
Figure 5 Example of FIPS tamper evidence labels. For reference only. May not represent actual drive. Note Seagate Laptop Thin SSHD SATA Product Manual, Rev. J... -
Page 24: About (Sed) Self-Encrypting Drives
The Trusted Computing Group (TCG) is an organization sponsored and operated by companies in the computer, storage and digital communications industry. Seagate's SED models comply with the standards published by the TCG. To use the security features in the drive, the host must be capable of constructing and issuing the following two SATA commands: ... -
Page 25: Random Number Generator (Rng)
In addition to providing a locking mechanism to prevent unwanted firmware download attempts, the drive also only accepts download files which have been cryptographically signed by the appropriate Seagate Design Center. Three conditions must be met before the drive will allow the download operation: 1. -
Page 26: Serial Ata (Sata) Interface
For detailed information about the Serial ATA interface, refer to the Serial ATA: High Speed Serialized AT Attachment specification. Hot-Plug Compatibility Seagate Laptop Thin SSHD SATA drives incorporate connectors which enable users to hot plug these drives in accordance with the Serial ATA: High Speed Serialized AT Attachment specification revision 2.0. This specification can be downloaded from . -
Page 27: Supported Ata Commands
Note: Individual Set Max commands are identified by the Address: value placed in the Set Max Features register as defined to Password: the right. Lock: Unlock: Freeze Lock: Set Max Address Ext Seagate Laptop Thin SSHD SATA Product Manual, Rev. J... - Page 28 ATA-standard power-management commands Check Power Mode Idle Idle Immediate Sleep Standby Standby Immediate ATA-standard security commands Security Set Password Security Unlock Security Erase Prepare Security Erase Unit Security Freeze Lock Security Disable Password Seagate Laptop Thin SSHD SATA Product Manual, Rev. J...
-
Page 29: Identify Device Command
Number of current logical heads xxxx Number of current logical sectors per logical track xxxx 57–58 Current capacity in sectors xxxx Number of sectors transferred during a xxxx Read Multiple or Write Multiple command Seagate Laptop Thin SSHD SATA Product Manual, Rev. J... - Page 30 100–103 ST500LM001 = 976,773,168 These words are required for drives that support the 48-bit addressing ST500LM020 = 976,773,168 feature. Maximum value: 0000FFFFFFFFFFFFh. ST320LM002 = 488,397,168 Streaming Transfer Time - PIO 0000 Seagate Laptop Thin SSHD SATA Product Manual, Rev. J...
- Page 31 Ultra DMA mode 6 is supported. Ultra DMA mode 0 is currently active. Ultra DMA mode 1 is currently active. Ultra DMA mode 2 is currently active. Ultra DMA mode 3 is currently active. Seagate Laptop Thin SSHD SATA Product Manual, Rev. J...
-
Page 32: Set Features Command
Free Fall Protection feature) Report full capacity available At power-on, or after a hardware or software reset, the default values of the features are as indicated above Note Seagate Laptop Thin SSHD SATA Product Manual, Rev. J... -
Page 33: Commands
S.M.A.R.T. Disable Operations S.M.A.R.T. Return Status If an appropriate code is not written to the Features Register, the Note command is aborted and 0x 04 (abort) is written to the Error register. Seagate Laptop Thin SSHD SATA Product Manual, Rev. J... - Page 34 Seagate Technology LLC 10200 South De Anza Boulevard, Cupertino, California 95014, United States, 408-658-1000 ASIA/PACIFIC Seagate Singapore International Headquarters Pte. Ltd. 7000 Ang Mo Kio Avenue 5, Singapore 569877, 65-6485-3888 EUROPE, MIDDLE EAST AND AFRICA Seagate Technology SAS 16-18 rue du Dôme, 92100 Boulogne-Billancourt, France, 33 1-4186 10 00 Publication Number: 100716628, Rev.
Need help?
Do you have a question about the ST500LX005 and is the answer not in the manual?
Questions and answers