Sata D P C Pd - Seagate ST500LM000 Product Manual

5.2 S ATA D
ERIAL
summarizes the signals on the Serial ATA interface and power connectors. Refer to the
Table 8
Table 8 Serial ATA Connector Pin Definitions
S P F
EGMENT IN UNCTION
S1 Ground
S2 A+
S3 A-
S4 Ground
S5 B-
S6 B+
S7 Ground
S
IGNAL
P1 V
33
P2 V
33
P3 V
33
P4 Ground
P5 Ground
P6 Ground
P7 V
5
P8 V
Power
5
P9 V
5
P10 Ground
P11 Ground or LED signal
P12 Ground
P13 V
12
P14 V
12
P15 V
12
N
OTES
All pins are in a single row, with a 1.27 mm (0.050 in) pitch.
1
The comments on the mating sequence apply to the case of backplane blindmate connector only. In this case, the
2
mating sequences are:
• the ground pins P4 and P12.
• the pre-charge power pins and the other ground pins.
• the signal pins and the rest of the power pins.
There are three power pins for each voltage. One pin from each voltage is used for pre-charge when installed in a blind-
3
mate backplane configuration.
All used voltage pins (V
4
S L T SSHD SATA P
EAGATE APTOP HIN
P C
EVICE LUG ONNECTOR
D
EFINITION
2nd mate
Differential signal pair A from Phy
2nd mate
Differential signal pair B from Phy
2nd mate
Key and spacing separate signal and power segments
3.3V power
3.3V power
3.3V power, pre-charge, 2nd mate
1st mate
2nd mate
2nd mate
5V power, pre-charge, 2nd mate
5V power
5V power
2nd mate
If grounded, drive does not use deferred spin
1st mate
12V power, pre-charge, 2nd mate
12V power
12V power
) must be terminated.
x
M
RODUCT ANUAL
P D
IN EFINITIONS
, R . D
EV
S ATA (SATA) I
ERIAL NTERFACE
below.
Notes
20