Positioning The Target - Microtek ScanMaker i800 Plus Supplement Manual

Features, scenarios, and information

Hide thumbs Also See for ScanMaker i800 Plus:

Table of Contents

Positioning the Target

Proper positioning of the target on the scanner is important for successful calibration.

Incorrect positioning of the target will result in an unsuccessful calibration.

A. Positioning the Reflective Target

1. Flip and place the reflective target on the scanner glass surface, making sure that

the top end of the target is positioned toward the back of the scanner, with its

edge firmly aligned against the ruler.

2. Using the scanner's top ruler as a point of reference, adjust the target so that it is

positioned at the center of the scanner glass bed.

B. Positioning the Transparent Target

1. Flip and place the transparent target inside the EZ-Lock 6 x 22 cm (120) Film

Holder; orientation of the target is critical. Refer to the section "C. Using the EZ-

Lock 6 x 22 cm (120) Film Holder" on page 10 of this manual to load the film.

2. Place the EZ-Lock 6 x 22 cm (120) Film Holder towards the back of the scanner,

with the loaded target on the scanner glass surface.

Important: Make sure that the

reflective target is facing down and

the side of the target (with the

barcode) is at the left side of the

scanner.

Important: Make sure that the

transparent target is facing down

and the side of the target (with the

barcode) is at the left side of the

scanner.

ScanMaker i800 Plus Supplement

Table of Contents

Do you have a question about the ScanMaker i800 Plus and is the answer not in the manual?